MIL-DTL-83413/8D
REQUIREMENTS:
Material:
Copper wire (except type C assembly): In accordance with A-A-59551, type R,
class undesignated (34 AWG strands), temper 1, coating T of the size specified in
table II.
Aluminum wire (type C assembly): Size 10, 37 strands of 0.0167 inch, electrical
grade, aluminum alloy, 1350 strands in accordance with ASTM B230/B230M,
concentric stranded, length of lay (pitch) .75 to 1.25 inch.
Copper terminals (except type C assembly): In accordance with SAE-AS7928,
under the applicable SAE-AS sheet as specified in table III through table V.
Aluminum terminals (type C assembly): Aluminum alloy in accordance with
SAE-AMS-QQ-A-225, ASTM-B211 or SAE-AMS-QQ-A-250 and ASTM-B209,
temper O with dimensions as specified in table V.
Coupler (assembly types "D", "E" and "F" only): In accordance with MIL-S-6852.
Identification band (types C, G and H only): Polyolefin, heat shrinkable in accordance
with SAE-AMS-DTL-23053/5. Color specified in table I.
Assembly resistance: See table II.
Tensile strength: See table II. Perform after the flexibility test in accordance with MIL-
DTL-83413, group II qualification sequence. Omit assembly resistance as a tensile
strength post test.
Crimping tools and crimping dies: See table II.
Marking (types C, G and H only): Part or Identifying Number (PIN) shall be marked on
the identification band. If the identification band is too short to accommodate the entire
PIN on a single line, the PIN may be put on two lines or both sides of the identification
band. Assembly type "C" parts shall be marked with an ink or fluid which is compatible
with fuel.
Salt spray: 48 hours in accordance with test procedure EIA/ECA-364-26.
Altitude-low temperature: Not applicable.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business